Corinthian
Performance Series

Corinthian Series

  • NMEA 0183 compatible
  • Data sharing capabilities
  • Fully waterproof from the front
  • Easy to read displays
  • Single power control when used with the CA220
  • Provides depth, speed, wind and coarse deviation
Corinthian Performance Series instruments provide basic depth, speed, and wind information for boaters for whom accuracy, clarity and dependability are always important and sometimes vital. Though simplicity and ease-of-use are trademark of the Corinthian line, these instruments don't take a back seat to any, with state-of-the-art electronics and full NMEA 0183 compatiblility, features found in today's most sophisticated instrument systems. All Corinthian Performance Series instruments have full NMEA 0183 data sharing capability. Each instrument can be daisy-chained to the next in the system to share relevant data or merge this data with other NMEA data received for use by other instruments.

Corinthian Performance Series SPECIFICATIONS

Power Requirements for Corinthian Performance Series Instruments: 11-15 VDC.
Red night lighting, adjustable in ten levels.
Environmental: Temperature Range: 0° to 55°C operating; -40°C to 70°C storage.
DCD400 Depthsounder
Depth: 2.4' to 400', meters or fathoms equivalent, Signal Strength indicator.
Transducer: ADX-100 in-hull. Frequency 200kHz. Depth Offset Variable ±9.9'
Alarm: Variable minimum and maximum depth alarms.
Shallow Gain: Front panel controlled.
Compass: Displays NMEA 0183 data from optional compass, °True or Magnetic depending on input.
Memory: Nonvolatile; stores unit selections, mode selection.
Interfaces: NMEA 0183 input; NMEA output for use by other NMEA 0183 compatible instruments.
Remote Alarm Output: 12VDC; 500 mA current limited.
Current Drain: 65 mA; 115 mA with mid-level night lighting; DCD400 being used as a remote:
50 mA; 100 mA with lights.
Optional Transducers: Removables: ADX-210 Nylon; ADX-215 Bronze; ADX-204 Bronze Stem-type.
Options: Remote indicating unit; additional DCD400.
DCS100 Speed/Log
Speed/Temp: 0.00 to over 35 knots (or Miles or Kilometers per hour) Actual Boat Speed, Average Speed; Damping Adjust. Sea Temp: 28.0 to 96.0°F (or ° C equiv.).
Transducer: ASTX-20NTH removable nylon thru-hull.
VMG: 0.00 to 99 knots with input from DCW360 Wind Machine.
Trip Log: 0.0 to 1999 miles.
Compass: Displays NMEA 0183 data from optional compass, °True or Magnetic depending on input.
Memory: Nonvolatile; stores configurations and calibrations.
Interfaces: NMEA 0183 input; NMEA output for use by other NMEA 0183 compatible instruments.
Calibration: Calibration via the front panel keypad
Current Drain: 40 mA; 85 mA with mid-level night lighting
DCS100 being used as a remote: 40mA; 85 mA lights.
Optional Transducers: ASTX-20BTH Bronze Removable; ASTX-20TM Transom Mount.
Options: Remote indicating unit: additional DCS100.
DCW360 Wind Machine
Direction: Full 360° pointer, electronically damped; Angle Accuracy: within 2°
Speed: 0 to 99 knots.
Accuracy: 1%
Masthead: DWX80MM mast mount sensor assembly with 80' 6-conductor shielded cable.
Interfaces: NMEA 0183 input; NMEA output for use by other NMEA 0183 compatible instruments.
Current Drain: 200 mA; 270 mA with mid-level night lighting DCW360 being used as a remote:
180 mA; 250 mA lights.
Options: DWX120MM with 120' cable; DWX55AM upright wind sensor. Remote indicationg unit; additional DCW360.
Calibration: Wind Angle, Damping from rear panel.
DCNR183 CDX Steering Indicator
Display: Analog with 0.01 NM resolution.
Miles Off Course Display: Analog; 0 to 0.3 off course, port or starboard.
Miles To Go Displayed: LCD; 0 to 99 miles to go to destination.
Resolution: 0.1 NM (under 10 miles), 0.01 (less than 1 mile).
Interface: NMEA 0183 compatible GPS or Loran, all Datamarine Electronic Charting Systems.
Current Drain: 170 mA; 240 with mid level night lighting.
DCA220 Control Panel
Display: Six digit LCD display.
Total Log: 0.0 to 99999.9 nautical miles. Units are independent of units selected for display on the DCS100 Speed/Log.
Trip Log: 0.0 to 99999.9 nautical miles since last reset.
LED indicates Trip Log is in view. Reset Trip Log with Select/Reset front panel key.
Units are independent of units selected for display on the DCS100 Speed/Log.
Power On/Off: Toggle key selection
True/Apparent Wind Selection: Toggle key selection
Lighting Control: Lights Increase and Lights Decrease keys.
Maximum Input Power: 1.5 amps, approximately 4 digital and 3 analog instruments.
Memory: Nonvolatile; stores configurations and calibrations.
Current Drain: 32 mA (no night lighting).
 
Specifications subject to change without notice or obligation.

[ Home ][ Top of Page ][ Dealers ]

Copyright © 1999-2008 Datamarine International Inc.. All Rights Reserved
Contact Us
Last Updated 01/22/2008